Glyptic

Purpose:
- It supervises a Style B (Class B) circuit of dry-contact input devices. This means it monitors devices like:
  - Manual fire alarm pull stations
  - Waterflow devices
  - Conventional heat detectors
  - Other normally-open dry-contact alarm activation devices.
Key Features:
- Compact Design: Its small size allows it to be installed in a single-gang electrical box behind the monitored device.
- Addressable: It’s used in intelligent, two-wire systems where each module has a unique address.
- SLC Loop Powered: It’s powered directly by the Signaling Line Circuit (SLC) loop, eliminating the need for additional power.
- LED Indication: It features an LED that flashes green during normal operation and turns steady red in an alarm condition.
- Built-in Type Identification: It automatically identifies itself to the fire alarm control panel.
- Wiring: Designed for ease of wiring.
Applications:
- Monitoring dry-contact devices in fire alarm systems.
- Monitoring supervisory devices.
- It can be used to replace MMX-101 modules in existing systems.
In essence:
- The FMM-101 is designed to provide a way for a fire alarm control panel to monitor the status of various dry contact devices. If the device changes state, the FMM-101 reports this change to the panel

Key Technical Specifications:

Nominal Operating Voltage:
- 15 to 32 VDC.
Current:
- Average Operating Current: Approximately 350 μA to 375 μA (varies depending on polling).
- Maximum Current Draw: Approximately 5.0 mA (LED on).
Initiating Device Circuit (IDC):
- Maximum IDC Wiring Resistance: 1,500 Ohms.
- Maximum IDC Voltage: 11 Volts.
- Maximum IDC Current: 450μA.
- EOL resistance: 47K Ohms.
Environmental:
- Temperature Range: 0°C to 49°C (32°F to 120°F).
- Humidity Range: 10% to 93% non-condensing.
Dimensions:
- Approximately: 1.3″ H x 2.75″ W x 0.5″ D.
SLC Wiring Resistance:
- Maximum SLC Wiring Resistance: 40 Ohms.
Addressing:
- Direct-dial entry of address: 01 – 159 on FlashScan loops; 01 – 99 on CLIP loops.

Key Features Related to Specifications:

SLC Loop Powered:
- Operates directly from the signaling line circuit.
Addressability:
- Uses rotary switches for address setting.
LED Indication:
- Provides visual status indication (green for normal, red for alarm).

Important Notes:

These specifications are intended as a general guide. Always refer to the official Notifier documentation for the most accurate and up-to-date information.
It is very important that all installation and wiring is done according to all local and national fire code regulations.

UL:
- This indicates that the device is Underwriters Laboratories listed, meaning it has met UL’s safety standards.
FM Approved:
- This signifies that the device has been approved by FM Approvals, which tests and certifies products for property loss prevention.
CSFM:
- This refers to certifications from the California State Fire Marshal.
MEA:
- This Refers to the Materials and Equipment Acceptance division of the New York city department of buildings.
ULC:
- This is the Canadian equivalent of UL.

No Project Found